Thin wall drip line/tape → PE submain

How to connect

Generally, connection to PE submains is made using a connector after a hole is made in the submain, and then using an inserter.

Create a hole in the poly hose submain that is slightly smaller than the outside diameter (OD) of the barb fitting. The dimension of the hole and tool to use is listed in the Rivulis Connectors brochure.

The above applies for on-ground PE hose only.

If installing to a buried PE submain, the installation will usually have a riser and you should refer to the Heavy wall drip line/LDPE → PVC/PE submain section, as the riser is usually LDPE.

Explore the next module, or search for a specific topic or issue.

Before using the content of the Knowledge Hub, please familiarize yourself with the relevant disclaimers and additional safety and usage information contained within the modules/guides being viewed. Keep in mind that due to numerous variances for every application, before making any product or application decision, as always, you should consult with a local irrigation consultant for your specific needs. Case study outcomes are for informational purposes only and actual results may vary.

© 2026, Rivulis Irrigation Ltd, all rights reserved. 
Reproduction of this content in any form is prohibited without the written consent of Rivulis Irrigation Ltd.